Dentek Temparin Temporary Filling 12+ Repairs

Repairs lost fillings and loose caps. Dentist recommended

Product Description

When you lose a filling or notice a loose crown, it’s not always possible to go to the dentist straight away. Temparin max offers you an effective short-term solution, allowing you to fill your tooth until you can see a dentist. It features the same ingredients used by dentists and an easy-to-use spade tool for applying the tooth-filling material.

This pack is enough for 12 or more repairs.

Usage / Instructions

Directions to replace a lost filling: Wash the cavity area with warm water and do not dry. Cut with spade tool or pinch a small amount of Temparin Max from the vial, and roll into a ball between fingers. Slightly overfill the cavity with Temparin Max and tamp into place with applicator tool tip. Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite. Use a moist cotton swab to remove excess Temparin Max from around the area. Moisture will accelerate the set. Temparin Max will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.

Directions to secure loose crowns, caps, or inlays: Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, then do not proceed further. If the crown has a post attached to it or if there is tooth surface remaining inside the crown, Temparin Max may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. Scoop a small amount of Temparin Max from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. Temparin Max will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear any excess material from around the crown, cap.